ALTECH ALpeel

Dispenser for self-adhesive labels

Automatic label peeling machine; peels the label from its backing paper and presents it to the operator for manual application
Ideal for labelling requirements which cannot be fully automated either due to complexity or cost
Photocell version for non transparent, opaque labels
Microswitch version for transparent labels and/or circular or special shaped labels
Compact version for small label reels and/or office environments

DWR LC - very compact and lightweight dispenser for roll-fed non-transparent self-adhesive labels.

The labels are read by two microprocessor-controlled self-learning sensors which can automatically identify the difference in transparency between the label and the paper liner, thus presenting the label almost fully peeled off on the peeler bar; when the label is removed, the next one is dispensed automatically.

The control board also allows motor rotation to be stopped when the reel finishes and paper breaks can also be accompanied by an acoustic warning signal.

Serie DWR - dispenser for self-adhesive labels

Designed for industrial environments, DWR is a semi-automatic dispenser for self-adhesive labels on rolls; constructed entirely in steel, it is simple to use and versatile enough for all types of labels commonly in use.

Available in versions for widths up to 100mm or 200 mm.

The reel holder, which adapts to all internal reel cores, accepts reels of up to 300mm in diameter, offering an impressive run time.

The labels are read by two microprocessor-controlled self-learning sensors which can automatically identify the difference in transparency between the label and the paper liner, this presenting the label almost fully peeled off on the peeler bar. When the label is removed, the next one is dispensed automatically. The control board also allows motor rotation to be stopped when the reel finishes and paper breaks can also be accompanied by an acoustic warning signal.

Power supply: 230V, or 115 V on request, no separate PSU required

An electromechanical sensor is available when using transparent labels which detects the difference in thickness between the label and the silicone liner paper.

An optional accessory for all models is a presettable electronic counter which counts the number of labels applied or else counts down from a preset number before stopping the label supply.

The battery-operated version makes it possible to work for around 5 hours with no mains power supply, depending on the label size and dispensing frequency.

The battery-operated dispenser does not require a separate battery charger since this is integrated in the control board – the unit will recharge automatically if left plugged in.